HQ7C1S - HPE Intelligent Management Center - Managing and Monitoring your Network – Englisch

This training course covers monitoring, man aging and configuring your edge to core network with the HPE Intelligent ManagementCenterSoftwarePlatform(HPEIMC). This course starts with a discussion of how HPE Intelligent Management Center is installed, how devices are added through discovery, and thenhowtheycanbeviewed.Thecoursealsogoesthrough configuration management—looking at VLANS in particular—and then explains how HPE Intelligent Management Center is used to manage both firmware and configuration on devices.
We also discuss how alarms are received and processed in HPE Intelligent Management Center along with trap management. Finally, we look at the Virtualization Resource Management (VRM) component against an ESXi host. The lab exercises are focused around Comware, Aruba Edge (AOS) and Aruba CX Switches, and some Cisco. This course is approximately 40 percent lecture and learning activities and 60 percent hands-on lab activities.

• HPE Intelligent Management Center Introduction
• Installation and Initial Access
• Adding Devices
• Trap Management
• View Management
• Configuration Management
• Alarms and Events
• VLAN Management
• Performance management
• Virtualization Management 

This course is intended for network or systems administrators, network engineers, and consultants who plan to deploy, manage, monitor and configure HPE Intelligent Management Center.

Learners should have some networking experience to get the most from this training course. They should:

• Understand networking
• Understand IPv4 addressing
• Have some knowledge of the CLI commands on HPE Aruba Switches (AOS and CX), Comware v7 and Cisco (this knowledge is beneficial, but not required)
• Understand file architecture on Comware and Aruba, including Telnet/SSH, and start up and saved configurations
• Understand SNMP configuration
• Understand traps and how they are configured on the switches